HP Virtual Connect 8Gb 20-port Fibre Channel Module for c-Class BladeSystem - Manual (Page 189)

Virtual Connect modules 189
Port Statistic Description
IfHCOutMulticastPkts
The total number of packets that higher-level protocols requested be
transmitted, and which were addressed to a multicast address at this
sublayer, including those that were discarded or not sent. For a MAC
layer protocol, this includes both Group and Functional addresses. This
object is a 64-bit version of ifOutMulticastPkts.
IfHCOutBroadcastPckts The total number of packets that higher-level protocols requested be
transmitted, and which were addressed to a broadcast address at this
sublayer, including those that were discarded or not sent. This object is a
64-bit version of ifOutBroadcastPkts.
Remote Device Information Description
remote_type
Type of remote device. Virtual Connect uses this information to configure
the link as an uplink, a stacking link, or to disable. This information is
based on the LLDP data sent by the device to which the port is attached.
remote_discovered_time Time the remote device was identified, represented in seconds. This
information is based on the LLDP data sent by the device to which the port
is attached.
remote_chassis_id_type Chassis ID subtype of the remote device.
remote_chassis_id Chassis ID value of the remote device.
remote_port_id_type
Port ID subtype of the remote device.
remote_port_id Port ID value of the remote device.
remote_port_desc Port description of the remote device.
remote_system_name
System name of the remote device. If the remote device is a VC-Enet
module, remote_system_name is the remote device's VC domain name.
remote_system_desc Description of the remote system. If the remote device is a VC-Enet module,
remote_system_desc is the module's hardware description and firmware
revision.
remote_system_capabilities System capabilities of the remote system, for example, repeater, bridge,
or router.
remote_mgmt_addr_type Management address subtype of the remote device, for example, IPv4,
IPv6, or DNS.
remote_mgmt_addr Management address of the remote device.
Pluggable Module Information Description
identifier Identifies the type of serial transceiver. The binary values are defined in
SFF-8472 in the Identifier [Address A0h, Byte 0] field. This field displays
an ASCII representation of those binary values.
ext-identifier Extended identifier for the type of serial transceiver. The values are
defined in SFF-8472 in the Extended Identifier [Address A0h, Byte 1]
field.
connector Connector type of the serial transceiver. The binary values are defined in
SFF-8472 in the Connector [Address A0h, Byte 2] field. This field displays
an ASCII representation of those binary values, such as “RJ45”.
vendor-name Name of the manufacturer (not HP). This is defined in SFF-8472 in the SFP
Vendor Name [Address A0h, Bytes 20-35] field.
vendor-oui IEEE company ID of the manufacturer (not HP). This is defined in SFF-8472
in the Vendor OUI [Address A0h, Bytes 37-39] field.