HP Virtual Connect 8Gb 20-port Fibre Channel Module for c-Class BladeSystem - Manual (Page 37)

Virtual Connect domains 37
To select a trap severity, do one of the following:
• Highlight the item, and then click the right arrow.
• Highlight the item, and then drag and drop it into the right window.
For a definition of trap severities, see "Trap severities (on page 33 )." When an event causes a trap to be
generated with the severity listed in the right window, it is sent to the trap destination. For VC-FC modules, the
trap severity is fixed at INFORMATIONAL and cannot be modified.
If you do not have the required privileges to select a category, that section is disabled. For a listing of trap
categories and the required administrative privileges, see "Trap categories and required administrative
privileges (on page
33 )."
SNMP Configuration (VC-FC)
By enabling SNMP for VC-FC modules, network management systems can monitor the VC-FC modules in the
domain for events, such as warnings and errors, which might require corrective actions. You must have
storage or domain administrator privileges to administer FC SNMP settings.
The VC-FC SNMP settings apply to all VC-FC modules in the VC domain.
The following table describes the fields within the SNMP Configuration screen.
Field name Description
Enable SNMP Select to enable SNMP.
Enable SMI-S Select to enable SMI-S
System Contact Specify a contact name for this system when SNMP is enabled. The maximum
length is 20 characters.
Read Community Controls SNMP read access when SNMP is enabled. The default value is "public".