HP 3PAR Recovery Manager Software for VMware vSphere Licenses - Manual (Page 54)

NOTE: The -defer option is not supported when the Recovery Manager for Exchange
backup server is the same as the production server.
•
-mp "mountpoint" - Optional. Specifies the mount point (delimited by quotation marks),
for a backup location other than in the default directory.
◦ Full path is required.
◦ Default is <System Drive>:\3parsnapshot.
◦ If the specified virtual copy is already mounted, this parameter will be ignored.
•
-lcr - Optional. Take the snapshot from the local continuous replication copy.
•
-active - Optional. One-step backup from the active CCR node (applies for CCR
configurations only, and can only perform backup for the node at the local site). The active
node is the default if -active is not specified.
•
-passive - Optional. One-step backup on the passive CCR node (applies for CCR
configurations only, and can only perform backup for the node at the local site). The active
node is the default if -passive or -active are not specified.
•
-noemail - Optional. Do not send an email notification even if configured for this operation.
•
-dl DataListName - Specifies the data list name and indicates the backup software in
use is HP Data Protector. For more information about data lists, see the description of backup
specifications in the HP Data Protector Administrator’s Guide.
Optional: If not specified, Recovery Manager for Exchange proceeds as if the backup software
used is Symantec NetBackup.
•
-domain <DomainName> - Optional. Specifies the domain to which the Exchange server
or storage group belongs.
If this option is not specified, Recovery Manager for Exchange uses the local domain.
NOTE: Use quotes ("") where spaces are included.
NOTE: Symantec NetBackup software is case sensitive. Make sure all information entered
pertaining to the policy is supplied with the proper case.
Example
The following command will perform a backup of virtual copy 020405162103 whose data has
currently been mounted.
RMExch backup -s bottlenosed -g sg2 -t 020405162103 -p test -d full -m
bottlenosed
The following command will use HP Data Protector to perform a backup of virtual copy
072211021532
using the backup specification (aka data list) rme_dl.
RMExch backup -s bottlenosed -g sg2 -t 072211021532 -dl rme_dl
54 Using the Recovery Manager CLI