HP LaserJet Pro M1536dnf MFP SERIES - Manual (Page 31)

Menu item Sub-menu item Description
Archive Print On
Off
When printing pages that will be stored for a long time,
this option sets the product to a mode that reduces
toner smearing and dusting.
The default setting is Off.
Firmware Date Displays the current firmware date code.
Restore Defaults Sets all settings to the factory default values.
Network Setup menu
Menu item Sub-menu item Description
TCP/IP Config Automatic
Manual
Automatic automatically configures all the TCP/IP settings via
DHCP, BootP or AutoIP.
Manual requires you to manually configure the IP address, subnet
mask, and default gateway.
The control panel prompts you to specify values for each address
section. Use the arrow buttons to increase or decrease the value.
Press the
OK button to accept the value and move the cursor to
the next field.
As each address is completed, the product prompts for address
confirmation before moving to the next one. After all three
addresses are set, the product automatically restarts.
Auto Crossover On
Off
Sets the auto crossover function.
Network Services IPv4
IPv6
Sets whether the product will use either IPv4 or IPv6 protocol.
Show IP Address Yes
No
Sets whether the product displays the IP address on the control
panel.
Link Speed Automatic
10T Full
10T Half
100TX Full
100TX Half
Sets the link speed manually if needed.
After setting the link speed, the product automatically restarts.
Restore Defaults Resets all network configurations to their factory defaults.
ENWW Setup menu 17