Configure trays – HP LaserJet Pro M1536dnf MFP SERIES User Manual
Page 71
Configure trays
By default, the product pulls paper from the priority input slot. If the priority input slot is empty, the product
pulls paper from Tray 1. Configuring Tray 1 on this product changes the heat and speed settings to
obtain the best print quality for the type of paper that you are using. If you are using special paper for
all or most print jobs on the product, change this default setting on the product.
The following table lists possible ways you can use the tray settings to meet your printing needs.
Paper use
Configure the product
Load both trays with the same paper, and
have the product pick paper from one
tray if the other one is empty.
●
Load paper in the priority input tray
or Tray 1. No configuration is
needed, if the default settings for
type and size have not been
changed.
From the software program, print the job.
Occasionally use special paper, such as
heavy paper or letterhead, from a tray
that usually contains plain paper.
●
Load special paper in Tray 1.
From the software program print dialog,
chose the paper type that matches the
special paper loaded in the tray and
select Tray 1 as the paper source before
sending the print job. Make sure that
there is no paper in the priority input slot.
Frequently use special paper, such as
heavy paper or letterhead, from one tray.
●
Load special paper in Tray 1, and
configure the tray for the paper
type.
From the software program print dialog,
chose the paper type that matches the
special paper loaded in the tray and
select Tray 1 as the paper source before
sending the print job. Make sure that
there is no paper in the priority input slot.
Configure the tray
1.
Make sure the product is turned on.
2.
Perform one of the following tasks:
●
Control panel: Open the System Setup menu, and open the Paper Setup menu. Select the
tray that you want to configure.
●
Embedded Web server: Click the Settings tab, and then click Paper Handling in the left
panel.
3.
Change the desired tray setting, and then press the
OK
button or click the Apply button.
ENWW
Configure trays
57