HP 1.10GB Virtual Connect Ethernet Module for c-Class BladeSystem - Manual (Page 37)

Virtual Connect domains 37
Select trap categories
Selecting a trap category allows multiple traps to be enabled or disabled as a group.
To select trap categories, click the checkbox. For VC-FC modules, selecting either the Port Status or Other
checkbox results in all SNMP traps being sent to the trap destination. VC-FC modules do not differentiate
between trap types. To select a VCM trap category, do one of the following:
• Highlight the item, and then click the right arrow.
• Highlight the item, and then drag and drop it into the right window.
Select trap severities
To select a trap severity, do one of the following:
• Highlight the item, and then click the right arrow.
• Highlight the item, and then drag and drop it into the right window.
For a definition of trap severities, see "Trap severities (on page 34 )." When an event causes a trap to be
generated with the severity listed in the right window, it is sent to the trap destination. For VC-FC modules, the
trap severity is fixed at INFORMATIONAL and cannot be modified.
If you do not have the required privileges to select a category, that section is disabled. For a listing of trap
categories and the required administrative privileges, see "Trap categories and required administrative
privileges (on page 33 )."
SNMP Configuration (VC-FC)
By enabling SNMP for VC-FC modules, network management systems can monitor the VC-FC modules in the
domain for events, such as warnings and errors, which might require corrective actions. You must have
storage or domain administrator privileges to administer FC SNMP settings.