HP Storage Mirroring Software - Manual (Page 325)

C - 17
7. Specify the following on the Double-Take Source Connection Parameters dialog box:
! Replication Set —Specify the name of the Storage Mirroring replication set. This name is case-sensitive and should
be the same name as specified in Configure the Storage Mirroring replication set on page C-15.
! Double-Take Target —Specify the name of the standalone target server.
! Allow connection scripts to interact with the desktop —Mark this check box if you want to display the connection
information in a command prompt dialog box.
! Logon to Target as —Allows you to specify an ID, password and domain to be used when logging on to the target.
8. Click Finish to complete the creation of the Double-Take Source Connection resource.
At this point, you are ready to bring the components online. But you cannot do that until the standalone target is up and
running. Therefore, you need to configure the target and then you will come back and bring the components online on the
cluster.
Configuring the standalone target
If you have not already done so, install Storage Mirroring on the target using the installation defaults.
The target machine should have drives or volumes with the same drive letters and are of the same approximate size as the
drives or volumes that are to be mirrored and replicated from the cluster nodes. No other special configurations is required
for the target machine, other than Storage Mirroring be up and running.
NOTE: If the script is set to interact with the desktop, the results will be displayed on the owning node. The
resource will remain at the
Online pending status until the script is manually acknowledged by a user.
Additionally, if you administer the cluster through Terminal Services, the command prompt windows
will not appear on your Terminal Services client, only on the nodes themselves. Therefore, this option
should not be a permanent setting, but should be used for troubleshooting if you are having problems
establishing a connection.
For additional information on the scripts used, see Understanding the Double-Take Source Connection
resource on page C-24.
NOTE: The user must be a member of the Double-Take Admin security group on all nodes of the cluster
running a Double-Take Source Connection resource.
If you do not specify a logon, the ID used to start the cluster service will be used. Verify that the ID
has
Double-Take Admin access.
NOTE: The Storage Mirroring installation will prompt you to reboot the machine. You can reboot at a later time, but
in order for Storage Mirroring to function properly and for you to finish these instructions, you must reboot.
For complete installation details, see the Getting Started guide.