HP XP LUN Configuration and Security Manager Software - Manual (Page 27)

LUN Configuration and Security Manager XP user guide for the XP10000/XP12000 27
2. In the LU Path tree on the LUN Manager main pane, right-click the host group and select Change Host
Group. The Change Host Group dialog box appears.
Figure 12 Change Host Group dialog box
NOTE: After you select the Option button, the pane expands to display check boxes. The check
boxes are numbered sequentially from left to right. The left-most check box on the upper row is #0,
and the check box immediately to the right is #1, and so on. The numbers indicate option numbers;
select check box #0 to select option #0.
3. To change the name of the host group, enter a new name in the Group Name box.
4. To change the host mode, select the new host mode from the Host Mode list.
5. If necessary, select Option, and select the host mode options. For detailed information about host mode
options, see Table 9 on page 24.
6. Click OK. The settings are shown in blue in the LU Path table.
7. Click Apply in the LUN Manager main pane. A confirmation message appears.
8. Click OK. The settings are applied to the disk array.
Deleting host groups
You cannot delete the host group 0 (zero). If you want to remove all the WWNs and LU paths from the host
group 0, you must initialize the host group 0 (” Initializing the host group 0 (zero) ” on page 27).
1. Start LUN Manager, and display the LUN Manager pane ( Figure 7 ).
2. In the LU Path tree on the LUN Manager main pane, right-click a host group and select Delete Host
Group. A confirmation message appears.
3. Click Yes to delete the host group. The host group you specified is removed from the LU Path tree.
4. Click Apply in the LUN Manager main pane. A confirmation message appears.
5. Click OK. The settings are applied to the disk array.
Initializing the host group 0 (zero)
Initializing the host group 0 sets the group to its default state. This process:
• Removes all the WWNs from the host group 0 and all the LU paths related to the host group 0.
• Changes the host mode of the host group 0 to Standard and initializes the host group name. For
example, if you initialize the host group 0 for the port CL1-A, the name of the host group 0 will change
to 1A-G00.
1. Start LUN Manager, and display the LUN Manager pane ( Figure 7 ).
2. In the LU Path tree on the LUN Manager main pane, right-click the host group 0 and select Clear Host
Group. A confirmation message appears.