HP Intelligent Infrastructure Analyzer Software - Manual (Page 24)

3. The Deactivate SAN Profile window is displayed with the following message:
Do you wish to deactivate the SAN Profile – XYZ (name of the SAN profile).
•
Click Yes to deactivate the SAN profile.
•
Click No to cancel the deactivation.
Delete SAN profile
To delete a SAN profile:
1.
Select any deactive SAN profile in the Manage SAN Profiles page.
2. Click Delete.
3. The Delete SAN Profile window is displayed with the following message:
Do you wish to delete the SAN Profile – XYZ (name of the SAN profile)
•
Click Yes to delete the SAN profile.
•
Click No to cancel the deletion.
NOTE: An active profile cannot be deleted.
Rescan SAN
Clicking on Rescan SAN initiates a data collection cycle for the active profile. This data collection
cycle is different than a system initiated cycle that occurs at an interval as set in the active profile.
Initiating a Rescan SAN request while the system initiated data collection cycle is in progress, the
system does not create a separate data collection cycle for rescan instead, the rescan is considered
as completed when the system initiated cycle ends.
To rescan a SAN profile, complete the following steps:
•
Click Rescan SAN from the navigation menu.
NOTE:
•
Rescan SAN works only on an active profile.
•
Data collection timeout is 30 minutes. However, the GUI will timeout after 40 mins if the rescan
is not complete for any reason.
HP IIAS terminologies
Inferred HBA
•
HBA connected Host is not supported by HP IIAS for discovering or monitoring. HBA is
connected to FC Switch, and FC Switch is discovered or monitored in HP IIAS.
•
HBA model is not supported by HP IIAS for discovering or monitoring. HBA is connected to
FC Switch, and FC Switch is discovered or monitored in HP IIAS.
•
HBA connected Host is not discovered or monitored in HP IIAS. HBA is connected to FC Switch,
and FC Switch is discovered or monitored in HP IIAS.
Monitored HBA
• HBA is connected to supported Host, HBA model is supported by HP IIAS for monitoring, and
Host is selected for monitoring in the profile. The connected FC Switch may or may not be discovered
or monitored.
24 Using HP IIAS