Installing the scsi interface cable, Table 3-1 – HP Integrity NonStop H-Series User Manual
Page 31
Cabling the Fibre Channel Converter
9800FC (CT9800FC) Fibre Channel Converter Installation and User’s Guide— 524957-003
3 -3
Installing the SCSI Interface Cable
Installing the SCSI Interface Cable
1. Before you install the 68-pin SCSI cable from the Fibre Channel converter to the
server, check that the tape drive and the Fibre Channel converter are both
powered off. Refer to
Appendix A, Multimode Fiber Optic Cables
for cable part
numbers.
2. Connect the 68-pin SCSI cable to the SCSI channel port on the Fibre Channel
converter.
3. Connect the other end of the 68-pin SCSI cable to a supported SCSI port on a
NonStop S-series server. For example, see
for the ServerNet/DA.
Table 3-1. Connections Supported for the Fibre Channel Converter
Server
ServerNet/DA
IOMF CRU
IOMF 2 CRU
PMF CRU
S7000
Yes
No
No
No
S7400
Yes
No
Yes
No
S70000
Yes
No
Yes
No
S72000
Yes
No
Yes
No
S74000
Yes
No
Yes
Yes
S76000
Yes
No
Yes
Yes
S86000
Yes
No
Yes
Yes