HP XP P9500 Storage - Manual (Page 65)

Also, ensure the following two settings using Storage Navigator Modular or Storage Navigator
Modular2:
•
Set the data transfer speed of the external port to a fixed value other than Auto.
•
Set the data transfer speed of the target port of the HUS/AMS/WMS storage system to a
fixed value consistent with the data transfer speed of the external port.
Parameter Settings Parameters Window Names
Start Attribute Boot Options
Specify when HUS/AMS/WMS is in a one-controller
configuration. Single Mode
Specify when HUS/AMS/WMS is a two-controller
configuration. Dual Active Mode
Optional Delay Planned Shutdown
Optional Drive blocking mode
HITACHI (default-do not change) Vendor ID
DF600F (default-do not change) Product ID
Optional ROM Microprogram Version
Optional RAM Microprogram Version
Optional Option System Parameter
Reset of occurred. Operation if the processor failure
occurs
Optional WEB Title
For AMS 1000, AMS 500, AMS 200 and WMS 100:
ON Write and verify mode
For HUS 150, HUS 130, HUS 110, AMS 2500, AMS
2300, AMS 2100, and AMS 2010: OFF
Optional Port Option Port Options
Set AMS common setting to Standard Mode. Host Connection Mode 1 Host Connection
Mode
Do not specify any parameters for AMS additional
settings. Host Connection Mode 2
For AMS 1000, AMS 500, AMS 200 and WMS 100,
do not specify HISUP OFF mode.
Identifying the HUS/AMS/WMS model using the serial number
When the external storage system is HUS, AMS, or WMS, you can identify the storage system
model from the serial number displayed in the Serial Number column in the Volume Operation
window.
The following table describes the relationship between the number in the Serial Number column
and the storage system model.
Model Displayed Serial Number Storage System
HUS 150 95XXXXX HUS
HUS 130 93XXXXX
HUS 110 91XXXXX
AMS 2500 87XXXXXX AMS
HUS/AMS/WMS 65