HP 1.10GB Virtual Connect Ethernet Module for c-Class BladeSystem - Manual (Page 47)

Domain management 47
The VC-Enet SNMP settings apply to all VC-Enet modules in the Virtual Connect domain.
The following table describes the fields within the SNMP Configuration screen.
Field name Description
Enable SNMP Select to enable SNMP
System Contact Specify a contact name for this system when SNMP is enabled
Read Community
Controls SNMP read access when SNMP is enabled. The default value for read
community string is "public". The read community string must always be set when
SNMP is enabled.
SNMP Trap Destinations SNMP trap destination table. The maximum number of trap destinations allowed is
five.
Destination User-designated name for the trap destination. The Destination name must be
unique.
IP Address IPv4 address or DNS name for the trap destination
Community String The Community String acts like a password for a given trap destination. The trap
receiving application can use the community string to filter the incoming traps.
Default: public
Format Format of the new trap. Select SNMPv1 or SNMPv2.
To add a trap destination, right-click on the header row of the destination table, and then select Add
Destination. See "Adding an SNMP trap destination (on page 48 )."