HP 1.10GB Virtual Connect Ethernet Module for c-Class BladeSystem - Manual (Page 28)

Domain management 28
Task Action
Use a VC domain IP address Select the box next to Use Virtual Connect Domain IP Address, and
then enter the IP Address, Subnet Mask, and Gateway.
Clear unsaved changes on the screen Click Clear.
Save changes and remain on this screen Click Apply.
Cancel without saving changes Click Cancel.
Domain Settings (Domain Enclosures) screen
Use this screen to import, delete, or add enclosures in the domain.
Multiple enclosures are supported only if an appropriate Primary and Secondary VC module is running in the
primary enclosure.
For additional information on adding and importing a remote enclosure and connecting multiple enclosures,
see the HP Virtual Connect for c-Class BladeSystem Setup and Installation Guide.
The following table describes the columns within the Domain Settings (Enclosures) screen.
Column Description
Enclosure ID Assigned ID of the enclosure
Enclosure name Name of the enclosure
Enclosure serial number Serial number of the enclosure
Rack name Name of the rack (assigned through the Onboard Administrator)