HP 3PAR Operating System Software - Manual (Page 264)

Description Column
Port firmware mode setting: Initiator, Target, Peer, or Suspended. Ports in Initiator mode
are connected to drive cages and ports in Target mode export to hosts. Suspended Mode
mode is for target ports that have not yet been initialized by the system (this is rare).
Peer mode is for Ethernet ports.
xThe partner port, in Node:Slot:Port format. (Displayed only on destination systems.) Partner
The WWN of the partner port. (Displayed only on destination systems.) Partner WWN
Indicates whether the system is in a failover state. (Displayed only on destination systems.) Failover State
The detail pane contains the following information:
Description Field Group
The port location in Node:Slot:Port format. Position General
Port World Wide Name. Port WWN
Node World Wide Name. Node WWN
Indicates whether the port is FC, iSCSI, RCIP, or RCFC. Type
The rate that data can be transferred over the port (1 Gbps, 2 Gbps or 4 Gbps).
When there is no specified value, no connection exists. Rate
The type of device that the port is connected to: Host or Peer. Connected Device
Type
The name of the system associated with the selected port. Connected Device
Port firmware mode setting. Ports in Initiator mode are connected to drive cages
and ports in Target mode export to hosts. Suspended mode is for target ports that Mode
have not yet been initialized by the system (this is rare). Peer mode is for Ethernet
ports.
The current state of the port. State
For iSCSI ports. The Media Access Control address for the Ethernet interface. MAC (not shown)
For iSCSI ports. The Target Portal Group Tag for the iSCSI target portal group. TPGT (not shown)
The type of port connection: Host or Peer. Connection Mode Settings
(displayed for
Connection type or port connection setting: Loop or Point. Connection Type FC and RCFC
ports)
Data transfer rate setting (such as 1 Gbps). Auto indicates that the system
automatically selects the rate. Configured Rate
Maximum rate of connection from the port. Max Rate
Indicates whether Fibre Channel service Class 2 is Disabled, Ack 1 or Ack 0. Class 2
For fabric attached ports, indicates the VLUN change notification setting. When
set to Enabled, notices are generated and sent to the fabric controller. When set
to Disabled, no notification is sent. VCN
Indicates whether the node's WWN is Enabled or Disabled. Unique Node WWN
If disabled, each I/O generates a separate interrupt to the HBA port driver rather
than generating one interrupt for multiple I/O completion. Interrupt Coalesce
For RCIP ports, the Media Access Control address of the Ethernet interface. MAC IP Settings
(displayed for
For iSCSI ports, indicates whether the Dynamic Host Configuration Protocol (DHCP)
protocol is enabled. DHCP RCIP and iSCI
ports - not
shown)
IP address of the iSCSI or RCIP port. IP Address
264 Using the Peer Motion Manager