HP 3PAR Operating System Software - Manual (Page 39)

The following information is provided:
Description Field Group
The port location in Node:Slot:Port format. Position General
The designated port label. Label
Port World Wide Name. Port WWN
Node World Wide Name. Node WWN
Indicates whether the port is FC, iSCSI, RCIP, or RCFC. Type
Rate that data can be transferred over the port (1 Gbps, 2
Gbps or 4 Gbps). When there is no specified value, no
connection exists. Rate
Type of device that the port is connected to. Free, Disk, Host,
Peer, or InServ. Connected Device Type
Name of device that the port is connected to, e.g. host1,
cage0. Connected Device
Port firmware mode setting. Ports in Initiator mode are
connected to drive cages and ports in Target mode export Mode
to hosts. Suspended mode is for target ports that have not
yet been initialized by the system (rare). Peer mode is for
Ethernet ports.
Current state of the port. State
The throughput in KB/sec. Total Data Throughput Resources
The type of port connection. Connection Mode Settings
Connection type or port connection setting (Loop, Point, or
Loop-point). When the port is set to Loop-point, both loop
and point-to-point connections are enabled. Connection Type
Data transfer rate setting (for example, 1 Gbps). Auto
indicates that the system automatically selects the rate. Configured Rate
Maximum rate of connection from the port. Max Rate
Indicates whether Fibre Channel service Class 2 is Disabled,
Ack 1 or Ack 0. Class 2
For fabric attached ports, indicates the VLUN change
notification setting. When set to Enabled, notices are VCN
generated and sent to the fabric controller. When set to
Disabled, no notification is sent.
Indicates whether the node's WWN is Enabled or Disabled.
Not available for systems running HP 3PAR OS 2.2.4 or
lower. Unique Node WWN
If Disabled, each I/O generates a separate interrupt to the
HBA port driver rather than generating one interrupt for Interrupt Coalesce
multiple I/O completion. Not available for systems running
HP 3PAR OS 2.2.4 or lower.
Type of connection (Private Loop, Public Loop, or Point-Point). Topology Fibre Channel Settings
Identifies which Fibre Channel classes of service are enabled
(2, 3, or 2/3). 2/3 indicates that both Class 2 and Class 3
are enabled. Class
Model of the Fibre Channel adapter that contains the port
(for example, QLOGIC 2302). Adaptor Type
Viewing System Ports 39