HP 3PAR Operating System Software - Manual (Page 308)

The following information for DC2 and DC4 drive cages is provided:
Description Column
The interface card name. Name
Four ports for each FC-AL. For FC-AL A, that is A0 through A3, and for FC-AL B,
that is B0 through B3. Ports
The status of Link A's fibre channel receiver of the SFP. Green if receiving signal;
off if not receiving signal. Link A RX LED
The status of Link A's SFP transmitter. Green if sending signal; off if not sending
signal. Link A TX LED
The status of Link B's fibre channel receiver of the SFP. Green if receiving signal;
off if not receiving signal. Link B RX LED
The status of Link B's SFP transmitter. Green if sending signal; off if not sending
signal. Link B TX LED
The system status. System LED
Link A speed. Link A Speed
Link B speed. Link B Speed
The state of Link A's SFP. Link A SFP State
The state of Link B's SFP. Link B SFP State
The following information for DC3 drive cages is provided:
Description Column
The interface card name. Name
Four ports for each FC-AL. For FC-AL A, that is A0 through A3, and for FC-AL B,
that is B0 through B3. Ports
Current state of port 0. Port 0 State
Current state of port 1. Port 1 State
Current state of port 2. Port 2 State
Current state of port 3. Port 3 State
Link speed for port 0. Port 0 Link Speed
Link speed for port 1. Port 1 Link Speed
Link speed for port 2. Port 2 Link Speed
Link speed for port 3. Port 3 Link Speed
Drive cage firmware status (Current, Not Current, Unknown). Firmware State
Current state of the interface card. State
The current state of the Enhanced Switch Hub. ESH State
308 Managing Drive Cages