HP 3PAR Operating System Software - Manual (Page 212)

RCIP Tab
The list pane of the RCIP tab displays summary information about the system's RCIP ports. The detail
pane displays details about a selected RCIP port from the list pane.
The following information is displayed in the list pane:
Description Column
The location of the port in node:slot:port format. Position
The Media Access Control (MAC) address of the connected device. MAC
The state of the port. See “System and Component Status Icons” (page 407) . State
IP address of the RCIP port. IP Address
Netmask address for the RCIP interface. Subnet Mask
The address of a local IP router on the same network as the system, used to forward
traffic to destinations beyond the local network. Gateway
Maximum Transmission Unit. The greatest amount of data or "packet" size that can be
transferred at one time over a particular network connection without overburdening the MTU
connection. The default MTU setting for an iSCSI port is 1500. When supported by the
network, an MTU value of 9000 should be used.
Rate that data can be transferred over the port (1 Gbps, 2 Gbps or 4 Gbps). When
there is no specified value, no connection exists. Rate
The following information is displayed in the detail pane:
Description Field Group
The port location in Node:Slot:Port format. Location General
Indicates whether the port is FC, iSCSI, RCIP, or
RCFC. Type
Rate that data can be transferred over the port (1
Gbps, 2 Gbps or 4 Gbps). When there is no
specified value, no connection exists. Rate
Type of device that the port is connected to. Free,
Disk, Host, Peer, or InServ. Connected Device Type
212 Configuring and Managing Remote Copy