Isns settings, Summary, Configuring fibre channel ports – HP 3PAR Operating System Software User Manual
Page 22: Configuring iscsi ports, General
5.
Click Next.
The iSNS Settings page appears.
iSNS Settings
1.
(Optional) Enter the Primary IP Address.
2.
(Optional) Enter the TCP Port number or accept the default.
3.
Click Next to view the Summary page, or click Finish to complete the configuration wizard.
Summary
Review your settings, then click Finish to complete the configuration wizard.
Configuring Fibre Channel Ports
To configure a Fiber Channel port, access the Fibre Channel Port Configuration wizard:
1.
In the Manager Pane, click Systems.
2.
In the Management Tree, select the system on which you wish to configure the port.
3.
In the Common Actions Panel, click Configure FC Port.
The Fibre Channel Port Configuration wizard appears.
4.
In the General group box:
a.
System list - Select the system on which the port will be configured.
b.
Port list - Select the port to be configured as a Fibre Channel port.
5.
In the Settings group box:
a.
Connection Mode list - Select the mode of the port as Disk, Host, or RCFC.
b.
Connection Type list - Select whether the connection type is Loop, Point, or Loop-point.
c.
Unique Node WWN - Enable or disable the node WWN.
d.
Configured Rate - Select Auto (default), 1 Gbps, 2 Gbps, 4 Gbps, or *8 Gbps.
e.
VLUN Change Notification (VCN) - Enable or disable the VLUN change notification.
f.
Interrupt Coalesce - Enable or disable the interrupt coalesce.
g.
Persona list - The port persona will be preselected based on the current configuration.
6.
Click OK.
*8Gbps for V-Class Systems only.
Configuring iSCSI Ports
To configure an iSCSI port, access the iSCSI Port Configuration wizard:
1.
In the Manager Pane, click Systems.
2.
In the Management Tree, select the system on which you wish to configure the port.
3.
In the Common Actions Panel, click Configure iSCSI Port.
The iSCSI Port Configuration wizard appears.
General
1.
In the General group box:
a.
System list - Select the system on which the port will be configured.
b.
Port list - Select the port to be configured as an RCIP port.
2.
In the IP Settings group box, perform the following:
a.
Select Obtain an IP Address automatically.
b.
MTU list - Enter the MTU value (maximum transmission units).
or
22
Managing Ports