Creating a peer motion configuration, Select systems – HP 3PAR Operating System Software User Manual
Page 225
Creating a Peer Motion Configuration
To use the Create PM Configuration wizard, the following conditions are required:
•
Verify that your storage systems meet all the requirements in the HP 3PAR-to-3PAR Data
Migration Guide
).
•
Super user role.
•
At least one available source system and destination system that are not in a Peer Motion
configuration.
Perform the following tasks before using the wizard:
•
Decide on the two host ports on the source system you will use. (You will need this information
to zone the source and destination systems.)
•
Configure the two host ports if not already configured.
The Create PM Configuration wizard guides you in configuring two peer ports on the destination
system and in zoning two systems into a Peer Motion configuration.
To create a Peer Motion Configuration:
1.
Select Peer Motion in the Manager Pane.
2.
Select Available Storage Systems in the Management Tree.
3.
In the Common Actions Panel, click Create PM Configuration.
The Create PM Configuration wizard appears.
Select Systems
1.
Click on the <Source> icon and select a source system.
2.
Click on the <Destination> icon and select a destination system.
3.
Click Next to go to the Set Up Connections page.
Creating a Peer Motion Configuration 225