HP 3PAR Operating System Software - Manual (Page 229)

Copying Storage Settings and Configurations
To use the Copy Storage Settings and Configurations wizard, the following conditions are required:
•
Super user role
•
At least one storage system to copy
•
Any valid Peer Motion configuration that has source and destination systems
This wizard guides the user in copying they following storage settings and configurations from the
source system to the destination system:
•
Domain sets
•
Domains
•
Host sets
•
Hosts
•
Users
•
LDAP configuration
•
NTP configuration
•
Syslog parameters
•
SNMP configuration
When there is no domain license on the destination system and the source system has domains,
a warning message is displayed that indicates that host sets, hosts, and users will be copied to the
<none> domain, and domain sets and domains will not be displayed.
NOTE:
•
Copying the NTP configuration is supported only when the user is configuring HP 3PAR Storage
Systems.
•
Syslog parameters are copied from the source system to the destination system, but the HP
3PAR Management Console has no syslog parameters management functionality.
•
The SNMP configuration is copied from the source system to the destination system, but the
HP 3PAR Management Console has no SNMP management functionality. Additionally, the
user settings are not copied.
If the simple copy operation does not meet your needs, the user can modify settings and
configurations on the destination system. The following existing HP 3PAR Management Console
commands might be used:
•
Create/Edit domain
•
Create/Edit domain set
•
Create/Edit host
•
Create/Edit host set
•
Create/Edit user
•
Create/Edit LDAP configuration
To copy storage settings and configurations:
1.
Select Peer Motion in the Manger Pane.
2. Select Peer Motion Configuration in the Management Tree.
3. In the Common Actions Panel, click Copy Storage Settings and Configurations.
The Copy Storage Settings and Configurations wizard appears.
Copying Storage Settings and Configurations 229