Clearing port parameters, Editing a port label, Resetting a port – HP 3PAR Operating System Software User Manual
Page 24: Setting a port offline
b.
Subnet Mask - Enter the RCIP port's subnet mask. The subnet mask is required.
c.
Gateway - Enter the RCIP port's gateway address.
d.
MTU list - Enter the MTU value (maximum transmission units).
e.
Speed list - Select the port speed as Auto (default), 10 Mbps, 100 Mbps, or 1 Gbps.
f.
Duplex list - Select the port's duplex value of either Half or Full.
6.
Click OK.
Clearing Port Parameters
NOTE:
This operation can only be performed on Remote Copy over Fibre Channel (RCFC),
Remote Copy over IP (RCIP), and iSCSI ports.
To clear a port's parameters:
1.
Access the ports Summary tab.
2.
Right-click the port to be cleared and then click Clear in the menu that appears.
The Clear Port Configuration dialog box appears.
3.
Click Yes.
Editing a Port Label
You may edit the designated label for all but RCIP and CNA ports. To edit a port label:
1.
Access the port summary screen.
2.
Right-click on the port whose label you want to change or click Edit Label in the toolbar.
3.
Select Edit Label.
The Edit Port Label dialog box appears.
4.
Enter the new label name in the Label text box.
5.
Click OK.
Resetting a Port
NOTE:
This operation cannot be performed on Remote Copy over IP (RCIP) ports.
To reset a port:
1.
Access the ports Summary tab.
2.
Right-click the port you wish to reset then click Reset in the menu that appears.
The Reset Port dialog box appears.
3.
(Optional) Select Reload Firmware if you wish to reload the port firmware upon reset.
4.
Click Yes.
Setting a Port Offline
NOTE:
This operation cannot be performed on Remote Copy over IP (RCIP) ports.
To set a port offline:
1.
Access the ports Summary tab.
2.
Right-click the port you wish to set offline then click Set Offline in the menu that appears.
The Set Offline dialog box appears.
3.
Click Yes.
24
Managing Ports