HP 3PAR Operating System Software - Manual (Page 384)

The Cage Subsystems Physical Disks tab displays the following information:
Description Column
The system name. System*
The disk name in Cage:Magazine:Disk format. Name
The manufacturer of the disk. Manufacturer
The SFP serial number. Assembly Serial Number
The part number of the SFP. Assembly Part Number
The disk's firmware version. Firmware Version
The type of physical disk: Fast Class (FC), Solid State (SSD), or Nearline (NL). Device Type
The protocol used by the device, e.g., FC or Serial Attached SCSI (SAS). Device Protocol
Speed of the specified disk. Device RPM
NOTE: The Device RPM number does not represent a rotational speed for the drives without spinning media (SSD).
It is meant as a rough estimation of the performance difference between the drive and the other drives in the system.
For FC and NL drives, the number corresponds to both a performance measure and actual rotational speed. For an
SSD drive, the number is to be treated as relative performance benchmark that takes into account in I/O per second,
bandwidth, and the access time.
The total capacity of the disk, in GiB. Total Capacity
Media type of as SSD device, such as Magnetic or Single-Level Cell (MLC or SLC). Media Type
The estimated remaining life of an SSD, as a percentage. The threshold limit is 95%. If
the remaining life exceeds the threshold (that is, 5% or less life remaining), the bar will
change from green to red. Life Remaining
*Not displayed when viewing information for an individual system.
Viewing the Cage Subsystems Power Supplies Tab
The Cage Subsystems Power Supplies tab displays information about the system's power supplies.
To access the Cage Subsystems Power Supplies tab, click the Power Supplies tab after accessing
the Cage Subsystem tab.
The Cage Subsystems Power Supplies tab displays the following information:
Description Column
The name of the system. System*
The drive cage name. Cage Name
The power supply name. Name
384 Viewing the Cage Subsystems Tab