HP 3PAR Operating System Software - Manual (Page 40)

Description Field Group
Indicates whether port mode change from initiator to target
or vice versa is Allowed or Prohibited. This setting is
configured using the InForm CLI command controlport. Mode Change
The number of hosts connected to the port. This is only
displayed if the port is connected to hosts. Hosts
The number of physical disks connected to the port. This is
only displayed if the port is connected to drive cages. Physical Disks
The
partner
port. Partner Virtual Port
The
WWN Partner WWN
of the
partner
port.
Indicates if the system is in a failover state. Failover State
Number for the current port persona setting. Persona Persona (not displayed
on systems using HP
Manufacturer of the host computers network adapter. This
value is determined by the port persona. Vendor
3PAR OS 2.3.1 or
higher)
Host computer's network adapter. This value is determined
by the port persona. Adapter Type
Host computers operating system. This value is determined
by the port persona. OS
Indicates whether the connection is Direct Connect or Fabric
Attached, as determined by the port persona. Connection
When a persona has been edited by a user, Modified
appears in this column. Otherwise, this column remains blank
(--). Modified
Physical Disks
The physical disk port information is presented on the Physical Disks tab.
The following information is provided:
Description Column
The arbitrated loop physical address of the device. AL_PA
The type of connected disk. Device
The position of the disk in the system. Position
The number of errors on the connected disk. I/O Error Count
The state of the disk. See “System and Component Status Icons” (page 407) . State
SFP
The Fibre Channel port SFP information is presented on the SFP tab.
40 Managing Ports