HP StoreEver MSL Tape Libraries - Manual (Page 18)

3 Installing and configuring the encryption kit
Identifying product components
Verify that you received all of the product components.
Figure 7 Encryption kit components
1. Two key server tokens
2. Accessory bag of token id cards and holders
3. Product documentation
Preparing the autoloader or library
Log in to the remote management interface
The key server token and autoloader or library encryption capabilities can only be configured from
the RMI.
•
MSL6480 — Log into the RMI as the security user. You will need the security user password.
The default password is security.
•
Autoloader and other libraries — Log into the RMI as the administrator user. You will need
the administrator user password.
If you have not used the RMI on this autoloader or library in the past, you may need to configure
the network on the autoloader or library before continuing.
See the getting started guide or user guide for your autoloader or library for instructions on
configuring the network and using the RMI. You can find these documents on the HP website at
http://www.hp.com/support/manuals .
Verify your autoloader or library firmware version
All MSL6480 firmware versions support the encryption kit.
For the autoloader or other libraries, verify that your autoloader or library firmware version supports
the encryption kit. If you see the Status > Security tab in the RMI, the firmware supports the encryption
kit. If this tab is missing, update the autoloader or library firmware to the current version. Neither
the administrator password nor token PIN are required to see the Status > Security tab.
18 Installing and configuring the encryption kit