HP ProLiant DL760 G2 Server - Manual (Page 101)

Installing Hardware Options, Server Power Off
5. Connect the expansion board I/O cable as appropriate.
HP has designed a self-latching slot-keeper feature to accommodate
full-length expansion boards.
Be sure that the V-shaped slot-keeper tabs on the plastic expansion board guide
are positioned over the forward end of the expansion board. Using the slot
keepers is especially important when expansion boards are added or when the
server is moved.
Figure 4-9: Full-length self-latching slot-keeper feature
6. Close the I/O lid, and slide the server into the rack.
7. Connect all power cords and power up the server (refer to Chapter 7).
8. If necessary, run the ROM-Based Setup Utility, as described in Chapter 8.
NOTE: For a list of supported I/O expansion boards, refer to the HP QuickSpecs for the
ProLiant DL760 G2 servers at
www.hp.com/products/servers/platforms .
NOTE: Each PCI-X bus is automatically configured to run in the most advanced mode
(PCI-X or PCI) and the highest frequency supported by all expansion boards installed in the
slots on the bus.
4-12 HP ProLiant DL760 Generation 2 Server User Guide
HP CONFIDENTIAL
Writer: Jennifer Hayward File Name: e-ch4 Installing Options-Power Off.doc
Codename: Pioneer Part Number: 201264-002 Last Saved On: 6/17/03 9:32 AM