Installing a hot-plug power supply, Installing a hot-plug power supply -34 – HP ProLiant DL760 G2 Server User Manual
Page 149
Installing Hardware Options, Hot-Pluggable
Installing a Hot-Plug Power Supply
The ProLiant DL760 G2 server ships with two hot-plug power supplies. The system
power in the ProLiant DL760 G2 server does not have to be shut off to replace one of
the power supplies.
WARNING: To reduce the risk of electric shock or damage to the equipment:
•
Install the power supply before connecting the power cord to it.
•
Unplug the power cord before removing the power supply from the server.
•
Disconnect power from the server by unplugging all power cords from
either the electrical outlet or the server.
CAUTION: To prevent data corruption, do not connect the server to a low line power
source (110 VAC). Low line power is not supported.
IMPORTANT: Most system configurations require 200-240 VAC. Use 200-240 VAC line cords
to power the server.
NOTE: A few server configurations may exceed the power rating of a single power supply
resulting in a loss of power redundancy for the server. Use the ProLiant DL760 G2 Power
Calculator available on ActiveAnswers to ensure that power redundancy will be maintained for
your configuration.
5-34
HP ProLiant DL760 Generation 2 Server User Guide
HP CONFIDENTIAL
Writer: Bryce Miller File Name: f-ch5 Installing Options-Hot Pluggable.doc
Codename: Comet Part Number: 201264-001 Last Saved On: 6/17/03 9:47 AM