HP ProLiant DL760 G2 Server - Manual (Page 84)

Server Access
5. Press in the module stop latches (1) and pull the module out of the chassis (2), as
shown in Figure 3-6.
Figure 3-6: Removing the processor and memory
module
WARNING: To reduce the risk of personal injury from hot surfaces, allow
the internal system components to cool before touching them.
6. At this point you can remove a processor board or add a processor board, as
described in Chapter 4.
NOTE: The top panel labels, processor board cover, and memory cartridge covers
provide instructions about installing processors and DIMMs.
7. To reassemble the server, slide the module into the chassis until the cam levers
begin to rotate. Then push the cam levers shut until they snap into place.
8. Connect all power cords.
3-8 HP ProLiant DL760 Generation 2 Server User Guide
HP CONFIDENTIAL
Writer: Jennifer Hayward File Name: d-ch3 Server Access.doc
Codename: Pioneer Part Number: 201264-002 Last Saved On: 6/17/03 9:26 AM