HP HSG Array Controller - Manual (Page 66)

3-32 StorageWorks Fibre Channel Storage Switch User's Guide
Compaq Confidential – Need to Know Required
Writer: Bill Reitz Project: StorageWorks Fibre Channel Storage Switch User's Guide Comments:
Part Number: AA-RHBYA-TE 135267-001 File Name: d-ch3 Managing the Switch Last Saved On: 4/7/99 11:59 AM
MIB-II Support
There are eleven groups of objects specified in MIB-II. The Switch’s SNMP
agent supports 3 of these groups. The three groups supported include:
■ System group (object ID is {iso, org, dod, internet, mgmt, mib-2, 1})
■ Interfaces group (object ID is {iso, org, dod, internet, mgmt, mib-2, 2})
■ SNMP group (object ID is {iso, org, dod, internet, mgmt, mib-2, 11})
The following variables are modifiable via the SNMP set command, given an
appropriate community with read-write access:
The Switch is shipped with the default identifiers.
SysDescr System description: the default value is set as “Fibre Channel
Switch”
sysObjectID System object identifier vendor’s authoritative identification
( 1.3.6.1.4.1.1588.2.1.1.1 )
sysUpTime The time since the agent was last initialized
sysContact The identification and contact information for this system.
By default, this is set as “Field Support”.
sysLocation The node’s physical location. The default setting is “End
User Premise”.
The interface group supports three interface drivers: software loopback,
Ethernet, and Fibre Channel IP.
Fabric Element MIB Support
There are five object groups defined:
■ Configuration group
■ Operation group
■ Error group
■ Accounting group
■ Capability group.
The agent supports all groups.