HP 3000 Enterprise Virtual Array - Manual (Page 49)

3. Enter the command admin start with the password config to enable administrator privileges.
4. Enter the set mgmt command and follow the prompts to set the management port properties to
enable HP Command View EVA to communicate with the mpx100/100b management port.
NOTE:
Changes to the management port using the set mgmt command are effective immediately.
Communications may be lost if Telnet was used to log in to the mpx100/100b.
5. Start HP Command View EVA and select the iSCSI Devices folder under the Hardware folder in
the HP StorageWorks Command View EVA window.
6. Click Discover iSCSI Devices ( Figure 12 ). If the iSCSI device is not discovered, click Add iSCSI
Device, enter the mpx100/100b IP address, and then click OK.
Figure 12 Discover iSCSI devices
.
7. Click iSCSI Controller 1 under Hardware/iSCSI Devices ( Figure 13 ).
EVA iSCSI Connectivity User Guide 49