HP 3000 Enterprise Virtual Array - Manual (Page 79)

iSCSI Initiator setup for Linux
Installing and configuring the SUSE Linux Enterprise 10 iSCSI driver
Configure the initiator using the built-in GUI-based tool or the open-iscsi administration utility using
the iscsiadm command. See the iscsiadm (8) man pages for detailed command information.
1. Modify the Initiator Name by issuing the following command:
# vi /etc/initiatorname.iscsi
2. To configure the Initiator and Targets, start the iSCSI Initiator applet by finding it in the YaST
Control Center under Network Services, and then set the service to start at boot time (
Figure 34 ).
Figure 34 Configure initiator and targets
. 3. Click the Discovered Targets tab and enter your iSCSI target IP address ( Figure 35 ).
Figure 35 Discovered Targets tab
.
EVA iSCSI Connectivity User Guide 79