HP 3000 Enterprise Virtual Array - Manual (Page 143)

restore : The FRU restore command requires that the user first ftp the
tar file containing the desired configuration to the mpx100/100b.
When this command is issued, it prompts the user for the restore level.
The user has the option of fully restoring the mpx100/100b
configuration (all configuration parameters and LUN mappings) or
restoring only the LUN mappings. The restored configuration does not
take effect until the mpx100/100b is rebooted.
save : The FRU save command creates a tar file containing the
mpx100/100b’s persistent data, configuration, and LUN mappings,
and stores the file in the mpx100/100b /var/ftp directory. The user
must then ftp the bin file from the mpx100/100b.
Keywords
The following is an example of the fru command:
mpx100/100b (admin) #> fru restore
A list of attributes with formatting and current values follows.
Enter a new value or press Enter to accept the current
value. If you wish to terminate this process before reaching the end of
the list press 'q' or 'Q' and Enter.
Type of restore (0=full, 1=mappings only) [full]
FRU restore completed.
Reboot the system for configuration to take effect.
The following is an example of the FRU Restore Save command:
mpx100 (admin) #> fru save
FRU save completed. Configuration File is HP_Storageworks_FRU.bin
Please use FTP to extract the file out from the System.
Examples
Help command
Displays a list of the CLI commands and their syntax.
Authority
help Syntax
EVA iSCSI Connectivity User Guide 143