HP 3000 Enterprise Virtual Array - Manual (Page 162)

The following is an example of the show iscsi command:
iSCSI Port Information
------------------------
iSCSI Port
1
Port Status Enabled
Link Status Up
iSCSI Base Name iqn.1986-03.com.hp:fcgw.mpx100:mpx100-74.0
MAC Address 00-c0-dd-0c-8d-c2
IP Address 33.33.66.73
Subnet Mask 255.255.0.0
Gateway IP Address 0.0.0.0
Firmware Revision No. 3.00.02.44
No. of Open Connections 0
Target TCP Port No.
3260
MTU Size Jumbo
Window Size 32768
Window Scaling Disabled
Current Port Speed 1Gb/FDX
Programmed Port Speed Auto
Header Digests Disabled
Data Digests Disabled
Max Burst 262144
Max First Burst 65536
VLAN Disabled
Examples
Show FC command
Displays FC port information for the specified port. If the port is not specified, both ports are displayed.
None Authority
show fc [<port_num>] Syntax
port_num : The number of the FC port to be displayed. Parameters
The following is an example of the show fc command:
mpx100 #> show fc 1
FC Port Information
---------------------
FC Port 1
Link Status Down
Current Link Rate Unknown
Programmed Link Rate Auto
WWNN
20:00:00:c0:dd:0c:60:11
WWPN 21:00:00:c0:dd:0c:60:11
Port ID 00-00-00
Firmware Revision No. 3.03.07
Frame Size 2048
Execution Throttle 64
Connection Mode Unknown
Programmed Connection Option Loop Preferred
Examples
Show Initiators command
Displays SCSI Initiator information for iSCSI and/or FC.
Command line interface 162