HP 3000 Enterprise Virtual Array - Manual (Page 221)

2. Click Browse and select the appropriate file name to restore.
3. Select Full Configuration Restore or Partial Restore (Mappings).
4. Click Start.
The Security Check dialog box is displayed.
5. Enter the password config, and then click OK.
6. Reboot the system for the configuration to take effect.
Restoring the configuration using the mpx100/100b CLI
To restore the configuration using the mpx100/100b CLI:
1. Establish an FTP connection to the mpx100/100b management port and log in:
Username: ftp
Password: ftp
2. Enter the following command to set the FTP transfer type to binary:
ftp> bin
3. Enter the following command to put the HP_StorageWorks_mpx100_FRU.bin file:
ftp> put HP_StorageWorks_mpx100_FRU.bin
4. Log in to the mpx100/100b using a Telnet session to the management port or console port.
Username: guest
Password: password
5. Enter the following command:
mpx100> admin start
6. Enter config as the password.
7. Enter the following command:
mpx100 (admin) #> fru restore
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the Enter key to accept the current
value. If you wish to terminate this process before reaching the end
of the list press 'q' or 'Q' and the Enter key to do so. Type of restore
(0=full, 1=mappings only) [full]
FRU restore completed.
8. Reboot the system for the configuration to take effect.
EVA iSCSI Connectivity User Guide 221