Installing the initiator for red hat 3 and suse 8, Installing the iscsi driver, Assigning device names – HP 3000 Enterprise Virtual Array User Manual
Page 82: 82 installing the iscsi driver
If there are problems starting the iscsi daemon, they are usually caused by an incorrect IP Address
or an ill-formatted initiator name.
Installing the initiator for Red Hat 3 and SUSE 8
If you are upgrading from a previous installation of an iSCSI driver, HP recommends that you remove
the /etc/initiatorname.iscsi file before installing the new driver. See the following website
for the latest version of the Linux driver for EVA iSCSI connectivity:
NOTE:
The Linux driver supports both Red Hat 3 and SUSE 8. See the
Readme file in the tar ball for more
information on how to configure the Linux iSCSI Initiator.
Installing the iSCSI driver
In a newly installed Red Hat Linux kernel, an iSCSI instance may be running. Before installing the
iSCSI driver, you must stop the instance.
To stop the instance:
1.
Run setup.
2.
Deselect iSCSI.
3.
Reboot the system.
See the Readme file in the tar ball for more information on configuring the iSCSI Initiator.
To install the iSCSI driver:
1.
Use tar(1) to decompress the source archive into a directory of your choice. The archive
contains a subdirectory corresponding to the archive name. Use the following commands to
decompress the source archive:
cd /usr/src
tar xvzf /path/to/linux-iscsi-version.tgz
cd linux-iscsi-<version>
2.
Compile the iSCSI driver. If your kernel sources are not in the usual place, add TOPDIR=/path/
to/kernel
or edit the definition of TOPDIR in Makefile. Use the Make command to edit
Makefile
.
3.
Install the driver as root. If you are currently using the iSCSI driver, first unmount all iSCSI devices
and unload the old iSCSI driver. If your Linux distribution includes an iSCSI driver, it may be
necessary to uninstall that package first.
4.
Configure the driver. See
Installing and configuring for RedHat 3, 4 and SuSE 8 and 9
Assigning device names
Because Linux assigns SCSI device nodes dynamically whenever a SCSI logical unit is detected, the
mapping from device nodes such as /dev/sda or /dev/sdb to iSCSI targets and logical units may
vary.
Setting up the iSCSI Initiator and storage
82