HP 3000 Enterprise Virtual Array - Manual (Page 87)

2. Verify that the iSCSI software packages are installed:
# pkginfo SUNWiscsiu SUNWiscsir
system SUNWiscsiu Sun iSCSI Device Driver (root)
system SUNWiscsir Sun iSCSI Management Utilities (usr)
3. Verify that you are running a Solaris 10 1/06 or later release.
4. Confirm that your TCP/IP network is set up.
Configure for EVA iSCSI target discovery
This procedure assumes that you are logged in to the local system where you want to configure access
to an iSCSI target device. The EVA target can be discovered by either using the IP address of the
MPX iSCSI port or using an iSNS server address.
Set target discovery using MPX iSCSI port address
To set target discovery using the MPX iSCSI port address:
1. Become a superuser.
2. Add the ip address of the mpx iSCSI port to the initiator’s discovery list:
# iscsiadm add discovery-address 33.33.66.64
3. Enable the SendTargetsdiscovery method:
# iscsiadm modify discovery --sendtargets enable
4. Create the iSCSI device links for the local system:
# devfsadm -i iscsi
5. Verify that mpx targets are available to the initiator:
# iscsiadm list target
NOTE:
The iSCSI connection is not initiated until the discovery method is enabled.
Set target discovery using iSNS server address
To set target discovery using the iSNS server address:
1. Become a superuser.
2. Add the ip address of the iSNS server to the initiator’s discovery list:
# iscsiadm add iSNS-server 33.33.66.64
3. Enable iSNS discovery method:
# iscsiadm mod discovery –isns enable
4. Enable the SendTargets discovery method:
# iscsiadm modify discovery --sendtargets enable
EVA iSCSI Connectivity User Guide 87