HP Netserver L Server series - Manual (Page 29)

Chapter 3 Startup and Navigation
23
Enables only monitoring functions to "Users."
•
Define Server Groups: Sets up server groups and individual server names
or IP addresses within each group.
•
Select Current Server Group (Ctrl+G): Displays the current contents of
the server selection box located in the FCArray Assistant window.
Functions in the same way as directly selecting the server selection box.
•
Select Current Controller (Ctrl+C): Displays the current contents of the
controller selection box located in the FCArray Assistant window.
Functions in the same way as directly selecting the controller selection
box.
•
RAID Assistant: HP’s FCArray RAID configuration utility. Facilitates
configuration tasks using one-step "automatic" configuration, a
configuration "wizard" assistant, or a manual (advanced-level)
configuration option allowing more control over configuration parameters.
•
Initialize Logical Drives: Offers the ability to run a full initialization of
logical drives at a time of your choice, NOT just immediately following a
new configuration.
If it’s inconvenient to follow a configuration immediately with a logical
drive initialization, you can decline the initialization and use this menu
item to start the process at a later time.
•
Display Controller Information: Displays key information about the
currently selected controller. The Controller Information window is read
only.
•
Controller Options: Sets various parameters for the selected disk array
controller. Unlike Controller Information, user definable controller
parameters are modified in Controller Options.
•
Intelligent BBU (Only enabled if the selected FCArray Controller has an
Intelligent Battery Backup Unit installed): Displays a dialog box from
which you can do the following:
◊ Monitor the power remaining in the Intelligent BBU.
◊ Request reconditioning of the Intelligent BBU.
◊ Set a low power alarm to indicate when the Intelligent BBU needs
recharging or replacement.