HP Netserver L Server series User Manual
Page 89
Chapter 4
Configuration
83
Figure 4-45. LUN Mapping in Simplex Mode
Consider the following points.
◊
The Clear All button sets all LUN assignments to None.
You can then select individual assignments more closely while
allowing several assignments of "inaccessible."
WARNING
DO NOT leave all assignments at None. This indicates there
are no logical drives accessible to any port on any controller.
◊
The Set Sequential button sets all LUN assignments sequentially on all
available ports. This reproduces the default shown in Figure 4-45.
◊
The Restore button resets the LUN Mapping assignments currently
saved in the configuration (the assignments in effect when the LUN
Mapping page was entered).
This is handy if LUN assignments become confusing and you wish to
cancel your changes.
◊
The Apply button applies the entire RAID Controller configuration,
including what was set up under the Disk Arrays, Logical Drives, and
LUN Mapping tabs.