HP VMA-series Memory Arrays - Manual (Page 115)

AM456-9007B Rev 02 HP VMA SAN Gateway Installation and User Guide 115
provides a list of available commands corresponding to the current mode. (Modes
are described in Command Modes on page 117.)
You can also query for options of a specific command by typing in the command,
following it with a space, and adding a question mark. After displaying a list of
options, the command line echoes the string and puts the cursor after it, ready for
more input.
For example, in Standard mode you can enter cli ? at the command line and see
the following output.
If the command is complete without further options or values, <cr> is displayed
on a separate line and the command is echoed at the prompt. Pressing the Enter key
(also known as carriage return, <cr> will then issue the command if no values are
required, or <value required> will be displayed.
> cli ?
clear-history Clear the command history for the current user
session Configure CLI options for this session only
> cli █