HP VMA-series Memory Arrays - Manual (Page 150)

150 AM456-9007B Rev 02 HP VMA SAN Gateway Installation and User Guide
[no] interface <ifname> zeroconf
The command may be used to enable or disable use of zero configuration
networking ( zeroconf ) on the specified interface. This randomly chooses a
unique Link Local IPv4 address from the 169.254/16 block. zeroconf is an
alternative to DHCP.
show interfaces [<ifname>] configured
show interfaces [<ifname>] brief
Display information about the specified interface, or all interfaces if one is not
named.
Either configured or brief or neither may be specified. With neither, detailed
information about the runtime state of the interface is given. With brief ,
abbreviated runtime state, with the interface statistics excluded, is shown. With
configured , the configuration of the interface is shown rather than its runtime
state.
Network Bond Commands
The network bond command enables you to define two or more network
interfaces (data ports) as a single logical address called eth0 and to define the mode
by which these interfaces are aggregated together.
network bond eth0 mode [balance-abalance-rr|backup|balance-
xor|balance-xor-layer3+4|broadcast|link-agg|link-agg-
layer2+3|link-agg-layer3+4|balance-tib|balance-alb]
interface <ifname> interface <ifname>
The command aggregates two interfaces together as a bonded group called eth0.
The interfaces share the same subnet.
Ten network bonding modes are supported:
balance-rr Round robin balancing
backup Backup fault-tolerant mode
balance-xor XOR load balancing
balance-xor-
layer3+4 XOR load balancing Layer 3 + 4 mode
broadcast Broadcast fault-tolerant mode