HP Designjet Z3200 PostScript Photo Printer series - Manual (Page 25)

8. When you reach the Select Printer screen, look for your printer's URL (which you noted in step 1)
in the Printer Name column.
● If you find the right printer name, scroll sideways to see the Connection Type column, and
check that it shows IP Printing. Then highlight that line. Otherwise, continue searching further
down the list.
● If you cannot find your printer name with an IP Printing connection type, check the box My
printer is not in the list.
Click Continue.
9. Continue following the instructions on the screen. When you reach the Printer Queue Created
screen, click Quit to exit, or Create New Queue if you want to connect another printer to the
network.
10. When the HP Printer Setup Assistant has finished, you can remove the CD from the CD drive.
If the printer driver is already installed, the HP Printer Setup Assistant can be run at any time from the
CD.
Connect directly to a computer (Mac OS)
You can connect your printer directly to a computer without going through a network, by using the
printer's built-in USB 2.0 socket.
1. Make sure the printer is either turned off or disconnected from the computer.
2. Insert the HP Start-Up Kit CD into your CD drive.
3. Open the CD icon on your desktop.
4. Open the Mac OS X HP Designjet Installer icon.
5. Follow the instructions on your screen. You are recommended to use the Easy Install option, which
will install the PostScript printer driver. If you would like to install the PCL3 (raster) driver, select
Custom Installation.
6. The printer software is installed, including the printer driver and the HP Printer Utility.
7. When the software has been installed, the HP Printer Setup Assistant starts automatically, to set
up a connection to your printer.
ENWW Connect directly to a computer (Mac OS) 15
S
o
ft
wa
re inst
all
a
ti
on