HP Designjet Z3200 PostScript Photo Printer series - Manual (Page 68)

● On the Embedded Web Server's Submit Job page: select Advanced settings > Roll
options > Rotate.
●
In the front panel: select the Setup menu icon , then Printing preferences > Paper >
Rotate.
NOTE: If rotation is set from your computer, it overrides the setting in the front panel.
NOTE: When you rotate a job, the page length may be increased to avoid clipping, because the top
and bottom margins are usually larger than the side margins.
NOTE: With either rolls or sheets, if you rotate an image to landscape whose original orientation was
portrait, the paper may not be wide enough for the image. For example, rotating a portrait D/A1-size
image on D/A1-size paper by 90 degrees will probably exceed the width of the paper. If you are using
the Embedded Web Server, the preview screen will confirm this with a warning triangle.
Autorotate
With some printer drivers, you can also select the Autorotate option, which will automatically rotate by
90 degrees any oversized portrait images in order to save paper.
Print with crop lines
Crop lines indicate where the paper should be cut to reduce it to your selected page size. You can print
crop lines automatically with individual jobs in the following ways:
● In the Windows driver dialog: select the Features tab, then Enable crop lines.
● In the Mac OS Print dialog (PostScript driver): go to the Finishing panel and select Enable
crop lines.
● In the Mac OS Print dialog (PCL3 driver): go to the Paper Type/Quality panel and select
Paper, then select Enable crop lines.
● On the Embedded Web Server's Submit Job page: select Advanced settings > Roll
options > Enable crop lines.
●
Using the front panel: select the Setup menu icon , then Printing preferences > Paper >
Enable crop lines > On.
To print crop lines with nested jobs (see Nest jobs to save roll paper on page 59 ), you must select a
different option:
● In the Embedded Web Server: select Job management > Use crop lines when nest is
enabled > On.
●
Using the front panel: select the Setup menu icon , then Job management > Nest
options > Enable crop lines > On.
Print on sheet paper
To print on cut-sheet paper, first load the sheet of paper (see Load a single sheet on page 33 ). Then:
● With a Mac OS printer driver or with the PostScript driver for Windows: select a paper size
described as “for sheet paper”, then select Manual Feed as the Paper Source.
● With the PCL3 driver for Windows: select Manual Feed as the Paper Source.
58 Chapter 5 Printing ENWW
Pr
in
ti
n
g