HP NonStop G-Series - Manual (Page 181)

Whether the processor has been frozen by a hardware error:
True: A hardware error in this processor caused it to freeze. (Disregard the Halt Code
and Lites Register values.)
False: This processor has not experienced a freeze caused by a hardware error.
Unknown: Hardware freeze state could not be read.
Hardware Freeze Flag
Online Boot Millicode Firmware
Online Boot Millicode Firmware Update is not supported for processors in S7000 PMF CRUs or on systems running
G06.11 or earlier. The related attributes and action are not displayed for processors on which this action is not
supported.
The name of the file to be used for the Boot Millicode firmware update. Default File Name
The version of the Boot Millicode currently running on the processor. Running Version
The version of the firmware to be used for the Boot Millicode firmware update. Default File Version
The differences, if any, between the running and default firmware versions. Values Compare State
Actions
Disable Processor Freeze
Turns off the Freeze Enable flag on this processor. A freeze-disabled processor both:
•
Participates in a system freeze only when the processor itself halts
•
Is unaffected when any other processor halts or the system Freeze action is performed
Halt
Terminates all processes running on this processor. Halting a processor does not affect any other processors in the
system.
CAUTION: Halting a processor might result in unrecoverable loss of data. Use the Halt action only to prepare for
reloading the processor or for performing a memory dump.
Hard Reset
The Hard Reset action stops the processor and terminates all processes running on it. Places the processor in a
known state, ready for a Prime for Reload action or Load action.
CAUTION: Use the Hard Reset action only when the Reset action fails. Use of Hard Reset action will erase register
information, rendering a memory dump useless.
Online Boot Millicode Firmware Update
Updates the Boot Millicode firmware running on the processor.
Online Boot Millicode Firmware Update is not supported for processors in S7000 PMF CRUs or on systems running
G06.11 or older. The related attributes and action are not displayed for processors on which this action is not supported.
Optional Parameter: File Name
Reload
Loads the operating system into the processor from a specific disk location.
Reset
Stops the processor and terminates all processes running on it. Places the processor in a known state, ready for a
Prime for Reload action or Load action.
Responsive Test
Verifies that the processor is configured and responding.
Processor 181