Shutdown parameters screen – HP UPS Network Module User Manual
Page 35
HP UPS Network Module web interface 35
2.
Enter the IP address or host name of the NTP server in the Hostname field.
3.
Select the time zone for your geographic area from the Time-Zone pull-down menu.
4.
Select the Disable radio button if daylight saving time should not be reflected in the time on the UPS
Network Module.
-or-
Select the Enable radio button to configure time adjustment for daylight saving time:
a.
Select the week number, day, month, and time for which daylight saving time should start. For
example, if daylight saving time starts the second Sunday of March at 2:00 am, select Second,
Sunday, and March, and then enter 02:00.
b.
Select the week number, day, month, and time for which daylight saving time should end. For
example, if daylight saving time ends the first Sunday of November at 3:00 am, select First,
Sunday, and November, and then enter 03:00.
c.
Select the amount of time the clock should change for daylight saving time in your region. Available
options are 30 minutes and 1 hour.
5.
Click Save to connect to the NTP server and set the date and time.
The UPS Network Module uses the NTP protocol (UDP 123 port). The firewall must be set to transmit
queries outside the network. No error message is generated if connection with the NTP server fails. The
UPS Network Module attempts to connect to the NTP server every 10 seconds until a connection is
made.
Click Help to view online help.
Shutdown Parameters screen
Click Shutdown Parameters in the menu tree to display the Shutdown Parameters screen. This screen allows
an administrator to configure how the UPS Network Module should shut down and restart the UPS and
attached devices in the event of a power failure.
The Shutdown Parameters table contains a row for the entire UPS and a row for each load segment. Settings
for the entire UPS apply to all load segments. Settings for individual load segments only apply to that load
segment.