Maintain paper, Change the drying time, Turn the automatic cutter on and off – HP Designjet Z2100 Photo Printer series User Manual
Page 48
8.
Once the new calibration parameters are calculated and stored, you are reminded to create an ICC
profile. Click Done. Your custom paper is added to the paper category you selected.
9.
To create an ICC profile, which allows you to print on your paper with the best possible color
accuracy, see
.
Maintain paper
To maintain paper quality, follow the recommendations below.
●
Store rolls covered by another piece of paper or cloth
●
Store cut sheets covered and clean or brush them before loading them in the printer
●
Clean input and output platens and cut sheet tray
●
Always keep the transparent window of your printer closed
NOTE
Photo and coated paper requires careful handling, see
Change the drying time
You may wish to change the drying time setting to suit special printing conditions such as multiple prints
where time is of higher importance or when you need to be sure ink is dry before handling.
Select the Setup menu icon
, then Print retrieval> Select drying time. You can select:
●
Extended, to set a longer than recommended time to ensure ink is completely dry
●
Optimal, to set the default and recommended time for your selected paper
●
Reduced, to set a shorter than recommended time when quality is of lower importance
●
None, to disable the drying time and remove your print as soon as it finishes printing
WARNING!
If the ink is not dry when the print is removed it could leave ink in the output tray
and marks on the print.
NOTE
If you cancel the drying time during a print, the printer may not feed and cut the paper
right away due to the printhead maintenance, which runs in parallel. If the dry time is zero, the
printer cuts the paper and then performs the printhead maintenance. However, if the dry time is
greater than zero, the printer does not cut the paper until after the printhead maintenance has
completed, even if the
Form feed and cut
key has been pressed.
Turn the automatic cutter on and off
To turn the printer's paper cutter on or off:
●
From HP Easy Printer Care (Windows), select the Settings tab and change the Cutter option in
Printer Settings > Advanced.
●
From HP Printer Utility (Mac OS), select Configuration > Printer Settings > Configure Printer
Settings and change the Cutter option.
38
Chapter 4 Paper handling
ENWW
P
ape
r ha
ndl
ing