HP Designjet Z2100 Photo Printer series - Manual (Page 49)

● From the Embedded Web Server, select the Setup tab, then Printer Settings, and change the
Cutter option.
●
Press the Menu key to return to the main menu, select the Setup menu icon , and then Print
retrieval > Enable cutter.
NOTE To cut rolled paper while the automatic cutter is disabled, see Feed and cut the paper
on page 39 .
Feed and cut the paper
To feed and cut the paper when the automatic cutter has been disabled, press the Form feed and cut
key on the front panel. The paper advances and the printer makes a straight cut on the front edge.
NOTE The printer may not cut the paper directly after the Form feed and cut key is pressed, as
each time a print is printed the printheads are serviced and the paper cannot be cut until the
process completes.
Remove the cut piece from the output tray.
WARNING! If strips or short prints are left in the output tray the printer could jam.
NOTE Photo and coated paper requires careful handling, see The print is scuffed or
scratched on page 130 .
ENWW Feed and cut the paper 39
Paper handling