HP Officejet H470wf Mobile Printer - Manual (Page 59)

To set up on an existing network with a USB cable (Windows or Mac OS)
You can set up your device on any wireless network if you have a USB cable nearby
to use for a temporary connection. Follow these steps to create a wireless connection
to the device:
1. Get all of the necessary settings for the wireless network. See
About 802.11
wireless network settings .
2. Close any running applications.
3. Insert the Starter CD into the CD drive. The CD menu runs automatically.
On the CD menu, click the button for the connection method you want to use.
4. On the CD menu, click Install (Windows) or Install Driver (Mac OS).
5. Follow the onscreen instructions to complete the software installation.
a. Enter the wireless network settings in the dialogs.
b. Temporarily connect a USB cable when prompted.
c. Mac OS only: Complete the installation using the HP Network Setup Tool,
which launches automatically during setup.
To configure additional 802.11 wireless profiles after you have set up the device, see
Configure and use 802.11 wireless profiles .
To set up on an existing network with no USB cable
This section describes connecting to an existing network with settings other than the
factory defaults, or setting up a new ad hoc (Windows) or computer to computer (Mac
OS) network that does not use the factory defaults, when all of the following conditions
are true:
•
You have a computer with 802.11.
• You do not have a USB cable.
• You have never set up the device to connect wirelessly.
If all of the above are true, then you will need to do the following:
1. Set up the device with a wireless connection using the factory defaults. See
Set up
for 802.11 using factory defaults .
2. Configure one of the three positions of the wireless profile switch with the desired
network settings using the Toolbox (Windows) or HP Network Setup Tool (Mac
OS). For more information, see
Configure and use 802.11 wireless profiles .
802.11 wireless connection 55