HP StorageWorks 6000 Virtual Library System - Manual (Page 248)

Action Status Description Item
One or more components have experienced an elev-
ated temperature or a thermal shutdown.
A thermal shutdown is indicated by the Therm Trip
LED.
• Be sure the processor heatsink is properly attached.
• Be sure there are no 1.7" DIMMs installed that
prevent airflow across the processor heatsink).
• Be sure that all fans are installed and working
properly.
• Be sure that the node environment meets posted
requirements.
For information about node environment requirements
refer to the “Optimum environment” section in Chapter
3.
Off = Normal
On = Attention
required
Temperature 5
DIMM failure or configuration error. Refer to the IML
or POST messages
Off = Normal
On = Attention
required
DIMM 6
A power fault on the system I/O board occurred. If
problem persists, replace the system I/O board.
Off = Normal
On = Attention
required
I/O power fault 7
The node experienced a thermal shutdown.
If one of the CPU thermal LEDs is amber, that CPU
experienced an overtemperature condition.
• Be sure that the processor heatsink is properly at-
tached. For more information, refer to the mainten-
ance and service guide.
• Be sure the correct DIMMs (1.2" tall) are installed.
• Be sure all fans are installed and working properly
For more information, refer to the maintenance and
service guide.
Off = Normal
On = Attention
required
Therm trip 8
Ensure the SCSI backplane is installed properly.
Reseat SCSI backplane board and hard drives.
Off = Normal
On = Attention
required
SCSI interlock 9
Look at the LEDs on the front of the power supply and
take the appropriate action.
Off = Normal
On = Attention
required
Power supply 1 10
Look at the LEDs on the front of the power supply and
take the appropriate action.
Off = Normal
On = Attention
required
Power supply 2 11
Component Identification 248