HP 3PAR System Reporter Software - Manual (Page 229)

8.37 Report Options
System Reporter 2.8 3PAR System Reporter User’s Guide
--All Nodes--
(Default). Specifies that nodes are not to be excluded based on their names.
<node>
This value consists of a controller node number (value is an integer between 0 and 7).
8.4.33.2 example:
The following example shows two ways to specify that nodes are not to be excluded based on
name:
The following example specifies that nodes 0 and 1will be included:
8.4.34 selnsp
Use the selnsp option to select ports according to their location.
8.4.34.1 value:
Specify one or more of the following:
--All Ports--
(Default). Specifies that no ports are to be excluded based on location.
<n:s:p>
This value consists of a port position location expressed in <n:s:p> format, where <n>
(0,1,2,3,4,5,6 or 7) is a node number (which depends on the number of nodes and the
storage server model),
<s> (0-5 for each node) is a node PCI slot numbered consecutively from left to right, and
<p> (1-4, depending on the type of adapter) represents an adapter port numbered
consecutively from top to bottom.
&selnode=
OR
&selnode=--All%20Nodes--
&selnode=0&selnode=1