HP Power Distribution Unit Management Module User Manual
Page 12
Installing the HP PDR Management Module 12
2.
Enter a description, select an icon for the connection, and then click OK. The Connect To window
appears.
3.
Select the serial connector on the host computer to which the DB-9 to RJ-45 adapter is attached, and
then click OK. The COM Properties window appears.
4.
Select the following parameter values, and then click OK.
o
Bits per second—115200
o
Data bits—8
o
Parity—None
o
Stop bits—1
o
Flow control—None
Configuring the management module for remote
access
1.
Be sure that you have connected the network cable ("Connecting the network cable" on page 10) to
the management module.
2.
Be sure that you have connected the configuration cable ("Connecting the configuration cable" on
page 10) to the management module and the host computer with an open terminal emulation
session.
3.
Press the Reset button on the management module front panel.
On the terminal emulation session screen running on the host computer, the POST executes, and the
following prompt appears:
Press any key in 5 seconds to enter Service menu.
4.
Press a key to enter the HP PDR Management Module Service Menu.
Use the HP PDR Management Module Service Menu to configure the minimum settings required to
access the management module remotely using telnet or the web interface. You can configure other
settings using this utility in conjunction with a terminal emulation program or a telnet connection.