Hp pdr management module quick setup, Quick setup information, Changing from bootp to a static ip – HP Power Distribution Unit Management Module User Manual
Page 70
HP PDR Management Module quick setup 70
HP PDR Management Module quick setup
Quick setup information
The HP PDR Management Module has one configuration port, one ModBus port, and one Ethernet port.
The quick setup can be done through the Service Menu (on page 51) or online Network Setup.
•
To access the Service Menu, use HyperTerminal with a serial connection.
•
To access online Network Setup, use a web browser if the assigned IP address is known.
To upgrade the firmware, use the HP Flash Utility with either a serial or network connection (FTP). If a
network connection is selected, enter the IP address, user name and password. For more information, see
"Updating the firmware ("Updating the firmware overview" on page 72)."
The PDR Management Module ships with BootP mode enabled. If the network DHCP server has BootP
enabled and configured, an IP address is automatically assigned to the module during the boot process. If
you have a serial connection and HyperTerminal open at the same time, write down the assigned IP
address for later use.
For the most current information, see the HP websit
Changing from BootP to a static IP
•
To access the Service Menu with a serial connection:
a.
Connect a serial cable to the configuration port.
b.
Open HyperTerminal with the following settings: 115200, 8, N,1,None.
c.
Press the Reset button or hot plug the PDR Management Module. Data appears on HyperTerminal
screen.
d.
When prompted to "Press any key within 5 seconds...", press the Space bar key. The Service
Menu appears.
e.
Select Network Settings to enter a static IP address and its subnet mask. Save and exit the menu.
f.
Press the Reset button. The new IP address is effective.
•
If an assigned IP address (BootP) was obtained:
a.
Open a browser window.
b.
Enter HTTP://xxx.xxx.xxx.xxx, and login to the PDR Management Module application.
c.
Select the Setup tab.
d.
Select the Network option.
e.
Enter a static IP address and its subnet mask. Save and exit the menu.